Enio EXP Board pinouts and scheme

Are you new to 6502, NES, or even programming in general? Post any of your questions here. Remember - the only dumb question is the question that remains unasked.

Moderator: Moderators

Post Reply
dark_cerberus
Posts: 9
Joined: Thu Nov 10, 2016 9:16 am

Enio EXP Board pinouts and scheme

Post by dark_cerberus »

Hey,

I recently bought an Enio EXP Board, but the wiki of it creater is down since a while and I can't found any manual online with the pinouts.
Anyone whould have saved it?

My goal is to plug a player 2 famicom controler with the MIC in it. But so far no luck.
My topic about it.
https://forums.nesdev.com/viewtopic.php?f=9&t=15147

Thanks a lot in advance :)
dark_cerberus
Posts: 9
Joined: Thu Nov 10, 2016 9:16 am

Re: Enio EXP Board pinouts and scheme

Post by dark_cerberus »

Thanks Myask,

Does it sounds possible to connect a famicom controler on the enio exp board for you?
Because so far in my attemps my NES freeze or player two doesn't move.

+----> Power (white)
|
5 +---------+ 7
| x x o \
| o o o o |
4 +------------+ 1
| | | |
| | | +-> Ground (brown)
| | +----> Pulse (red)
| +-------> Latch (orange)
+----------> Data (yellow)

I been looking and i don't see any latch pulse or data in the enio scheme.
/\
| \
GND | 01 \
| 09 | /OE for joypad 2
SOUND | 02 |
| 10 | Out 2 ($4016.2)
IRQ | 03 |
| 11 | Out 1 ($4016.1)
Joypad 2 D4 | 04 |
| 12 | Out 0 ($4016.0, Strobe)
Joypad 2 D3 | 05 |
| 13 | Joypad 1 D1
Joypad 2 D2 | 06 |
| 14 | /OE for Joypad 1
Joypad 2 D1 | 07 |
| 15 | +5V
Joypad 2 D0 | 08 /
| /
\/
Post Reply