nesdev.com
http://forums.nesdev.com/

SMB1 IRQ issues - Making sure that MMC3 split works
http://forums.nesdev.com/viewtopic.php?f=2&t=12347
Page 1 of 1

Author:  Hamtaro126 [ Fri Feb 06, 2015 8:27 pm ]
Post subject:  SMB1 IRQ issues - Making sure that MMC3 split works

I've found out how MMC3 IRQs work a bit, but making it work similar to SMB2J kind of does not work.

I've tried, but it just crashes...

Will post or PM the code if needed, it uses ASM6, and excludes the sound engine.

This is not Sprite 0 related, That is already taken care of, it's an Interrupt-based problem, it's either on an endless loop or something else.

Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/