It is currently Sun Nov 19, 2017 5:26 pm

All times are UTC - 7 hours





Post new topic Reply to topic  [ 31 posts ]  Go to page Previous  1, 2, 3
Author Message
PostPosted: Mon Oct 30, 2017 10:53 am 
Offline
User avatar

Joined: Sun Jan 22, 2012 12:03 pm
Posts: 5822
Location: Canada
pinkpuff wrote:
FCEUX has been set to New PPU the whole time. The status bar is still rock solid in that one.

Ah, I am surprised by this because on the first ROM you posted I saw a flickering white artifact on the split line with New PPU but not Old PPU. (The overlay wasn't moving up or down, though, so it stable.)

pinkpuff wrote:
I put in a loop to delay the scroll write until Nintendulator was reporting it happening at a tick somewhere in the low 300s (305 to about 311; it varies a bit). It was still jittery. Is that during hblank? I wasn't quite sure from the link, but I got the impression that it's basically any time after tick 257?

I think I should have linked Wiki: PPU Scrolling instead, it has more relevantly digested information.

So, the PPU is going to increment the Y scroll at pixel 256, and then won't start incrementing the X scroll until pixel 328. This is your window of opportunity. (The other option is to update scroll somewhere in the middle of the scanline, any time before pixel 256, leaving a rough edge and fine X scroll will be off until the next line-- that's what most games did, and it's a very wide window to hit.)

The timing of any interrupt will vary up to i think 6 cycles (18 pixels) depending on what instruction it interrupted, so try to look for the low and high point this far apart. If you've only seen 305 to 311, you might not have caught the extremes. Maybe to help testing, you have a LDA $10 / BNE wait loop, but you could temporarily add a little JSR / RTS into that loop for more variability of timing?

Also, to keep the window as tight as you can, you can do the BIT $2002 early, and preload X or Y if needed to hold values to write quickly to $2006/2005. The first write to $2006 can be done early as well, as its effect is buffered. In your case, only the second $2006 and then the $2005 need to actually occur within hblank, because they're what take immediate visual effect. The actual stuff that happens in hblank should be as minimal as possible, ideally just the write instructions, no loads.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 31 posts ]  Go to page Previous  1, 2, 3

All times are UTC - 7 hours


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group