Hi,
(I know how IE/IF sets the trigger, so that's not the question)
So i find this a little bit confusing.
From my understanding, the Interruptions is launched before fetching the next instruction.
But is that also when the check for IF/IE happens, or does that happen on the cycle where either IF or IE is changed?
Cause you could basically set/unset IF/IE within one instruction cycle, and then when fetching the next instruction,
it would look like nothing happened etc.
Thanks:)
When are Interruptions signaled and launched?
-
- Posts: 68
- Joined: Tue May 17, 2016 10:15 pm