When are Interruptions signaled and launched?
Page 1 of 1

Author:  zerowalker [ Fri May 04, 2018 9:57 am ]
Post subject:  When are Interruptions signaled and launched?


(I know how IE/IF sets the trigger, so that's not the question)

So i find this a little bit confusing.

From my understanding, the Interruptions is launched before fetching the next instruction.
But is that also when the check for IF/IE happens, or does that happen on the cycle where either IF or IE is changed?

Cause you could basically set/unset IF/IE within one instruction cycle, and then when fetching the next instruction,
it would look like nothing happened etc.


Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB® Forum Software © phpBB Group