It is currently Mon Oct 16, 2017 3:21 pm

All times are UTC - 7 hours



Forum rules


1. NO BLATANT PIRACY. This includes reproducing homebrew less than 10 years old, with the exception of free software.
2. No advertising your reproductions, with the exception of free software.
3. Be nice. See RFC 1855 if you aren't sure what this means.



Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sun Nov 27, 2016 12:26 pm 
Offline

Joined: Mon Oct 24, 2016 2:35 am
Posts: 13
I tried to do a Mega Man Wily Wars repro by using a College Football's National Championship donor cartridge.

I downloaded a Mega Man Wily Wars .md ROM, used GQ USB Programmer for the Byte Swap, saved the .bin file separately and wrote it onto a 27C160 EPROM.
I also used the tool FixCheckSum before writing the EPROM, as (for some reason) the checksum is always incorrect after byteswapping.

However, when I try to launch the game in my Mega Drive, I only see a red screen. I have no clue what could be wrong, as there isn't any wiring needed.

Does anyone have an idea?


Top
 Profile  
 
PostPosted: Mon Nov 28, 2016 3:58 pm 
Offline
User avatar

Joined: Sat Jul 04, 2015 9:58 am
Posts: 526
Location: -29.794229 -55.795374
Well, red screens means checksum errors that are usually caused by bad contact on dirty connectors.

I had the same problem recently on a Megadrive repro I've made and it was one of the data lines that had a bad soldering on it. Specifically it was D12, but can be any other in your case.

Does the byteswapped file run on an emulator? You may try to write it without byteswap, if possible in the same IC.
You can take a look on the file you intend to write on a hex editor, starting at offset 0x100 it should say something like "SEGA MEGA DRIVE" followed by some licensing information.

I'm not sure, but the checksum errors after byteswapping could mean that you don't need byteswapping at all.


Top
 Profile  
 
PostPosted: Thu Dec 08, 2016 8:45 pm 
Offline

Joined: Thu May 14, 2015 6:17 pm
Posts: 159
Don't fix the checksum on byte swap. Take a clean rom and open in the programmer, hit byte swap in the programmer and then write. That is all you need to do. You are over thinking it and causing yourself problems.


Top
 Profile  
 
PostPosted: Fri Dec 09, 2016 8:54 am 
Offline

Joined: Sun Dec 02, 2012 8:17 am
Posts: 483
Location: East Texas
You could use this pcb https://www.mortoffgames.com/sega-genes ... game-board for repos where you don't have to byte swap the rom files.

Edit: I meant you could use this pcb as a non-byte swap alternative. Since this pcb doesn't have sram, it would not be the ideal choice for MMWW.
A fully assembled SRAM version (less the rom of course) pcb will be available in the near future though.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 7 hours


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group