It is currently Fri Aug 23, 2019 12:14 am

All times are UTC - 7 hours

Forum rules

1. NO BLATANT PIRACY. This includes reproducing homebrew less than 10 years old, with the exception of free software.
2. No advertising your reproductions, with the exception of free software.
3. Be nice. See RFC 1855 if you aren't sure what this means.

Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sun Nov 27, 2016 12:26 pm 

Joined: Mon Oct 24, 2016 2:35 am
Posts: 13
I tried to do a Mega Man Wily Wars repro by using a College Football's National Championship donor cartridge.

I downloaded a Mega Man Wily Wars .md ROM, used GQ USB Programmer for the Byte Swap, saved the .bin file separately and wrote it onto a 27C160 EPROM.
I also used the tool FixCheckSum before writing the EPROM, as (for some reason) the checksum is always incorrect after byteswapping.

However, when I try to launch the game in my Mega Drive, I only see a red screen. I have no clue what could be wrong, as there isn't any wiring needed.

Does anyone have an idea?

PostPosted: Mon Nov 28, 2016 3:58 pm 
User avatar

Joined: Sat Jul 04, 2015 9:58 am
Posts: 957
Location: -29.794229 -55.795374
Well, red screens means checksum errors that are usually caused by bad contact on dirty connectors.

I had the same problem recently on a Megadrive repro I've made and it was one of the data lines that had a bad soldering on it. Specifically it was D12, but can be any other in your case.

Does the byteswapped file run on an emulator? You may try to write it without byteswap, if possible in the same IC.
You can take a look on the file you intend to write on a hex editor, starting at offset 0x100 it should say something like "SEGA MEGA DRIVE" followed by some licensing information.

I'm not sure, but the checksum errors after byteswapping could mean that you don't need byteswapping at all.

PostPosted: Thu Dec 08, 2016 8:45 pm 

Joined: Thu May 14, 2015 6:17 pm
Posts: 159
Don't fix the checksum on byte swap. Take a clean rom and open in the programmer, hit byte swap in the programmer and then write. That is all you need to do. You are over thinking it and causing yourself problems.

PostPosted: Fri Dec 09, 2016 8:54 am 

Joined: Sun Dec 02, 2012 8:17 am
Posts: 503
Location: East Texas
You could use this pcb ... game-board for repos where you don't have to byte swap the rom files.

Edit: I meant you could use this pcb as a non-byte swap alternative. Since this pcb doesn't have sram, it would not be the ideal choice for MMWW.
A fully assembled SRAM version (less the rom of course) pcb will be available in the near future though.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 7 hours

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group