nesdev.com
http://forums.nesdev.com/

29f160 wiring help
http://forums.nesdev.com/viewtopic.php?f=28&t=17884
Page 1 of 1

Author:  GalacticScum [ Sat Oct 06, 2018 3:36 am ]
Post subject:  29f160 wiring help

[list=]Hi, i've desoldered few 29f160 flash eeproms in tsop48 package and i want to do an adapter pcb for Snes. Is there any diagram showing which lines do i need exacly...? Or can anybody tell me how to wire it up propertly for 1 to 1 replacement? And what to do with unused address lines... Leave them unconnected or solder to gnd? [/list]

Author:  tepples [ Sat Oct 06, 2018 6:31 am ]
Post subject:  Re: 29f160 wiring help

Ground the unused address lines.

Unused inputs should always be connected to something unless the datasheet specifies that an input is internally pulled up or down. And I haven't heard of a commodity flash memory with pullups or pulldowns on its address lines.

Author:  GalacticScum [ Sat Oct 06, 2018 11:10 am ]
Post subject:  Re: 29f160 wiring help

Ok, ty... At that moment i've got :29L323DT 32mbit (4Mx8/2Mx16),29F160BE 16mbit (2Mx8/1Mx16) and 29LV800CT 8mbit (1Mx8/512Kx16) all TSOP48. How to write the game... Can i Just write it in one chunk or have to split and use multiplexer?

Author:  lidnariq [ Sat Oct 06, 2018 11:35 am ]
Post subject:  Re: 29f160 wiring help

Look at the datasheet, if it can run in 8-bit mode, you don't need a multiplexer.

HOWEVER. The letter "L" indicates a 3V part. Do not use one in your (or anyone else's) SNES without adding additional protection parts, 3V ROMs will damage the console and/or be damaged by it.

Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/