Hello im having hard time figuring the pin holes for these cartridge slot edge connectors for these consoles nes,snes,n64,sega genesis.Trying to make a board to mount the connectors and then a ribbon cable or header connectors to connect.I have done the solder the wires to cartridge slot edge connector to main console board alot of wires to solder i want to put it on a PCB board i just cant figure out pin holes and size of the connectors.Here what im trying to do in some pictures where i solder the wires to the connector and to main board of the console.
help with PCB design cartridge slot extender
Moderator: Moderators
-
- Posts: 3
- Joined: Sat Feb 01, 2020 10:41 pm
Re: help with PCB design cartridge slot extender
That looks like a lot of work! What's it for? Are you planning on making some sort of frankenstein all-consoles-in-the-same-box project?
-
- Posts: 3
- Joined: Sat Feb 01, 2020 10:41 pm
Re: help with PCB design cartridge slot extender
Have you made any progress on this project of yours?
For game updates: https://twitter.com/MonsoonStu
-
- Posts: 3
- Joined: Sat Feb 01, 2020 10:41 pm
Re: help with PCB design cartridge slot extender
heres a update of pcb board
layers : 5
minimum trace width : >=10 mil
minimum trace spacing : >=10 mil
minimum drill size : 0.2 mm
width : 235.33 mm
height : 112.52 mm
layers : 5
minimum trace width : >=10 mil
minimum trace spacing : >=10 mil
minimum drill size : 0.2 mm
width : 235.33 mm
height : 112.52 mm