It is currently Thu Aug 17, 2017 2:20 pm

All times are UTC - 7 hours





Post new topic Reply to topic  [ 124 posts ]  Go to page Previous  1 ... 5, 6, 7, 8, 9
Author Message
PostPosted: Wed May 17, 2017 12:09 pm 
Online

Joined: Sun Apr 13, 2008 11:12 am
Posts: 6028
Location: Seattle
Basically, the amount of branching wire you can get away depends on the lengths of the branches and the frequencies involved. A very short Y such as perhaps 6 inches, when used at the 400kHz frequency that's used by the Nunchuk, will be assuredly functional.

On the other hand, two 10 foot long tails after the branch ... that's asking for it to be unreliable.


Top
 Profile  
 
PostPosted: Sat Jun 10, 2017 9:07 pm 
Offline

Joined: Sat Jun 10, 2017 8:57 pm
Posts: 2
Hey all,

I am new here and I created an account just to see if anyone would be wiling to help me.

I have successfully soldered a carrier in place of the Flash chip on the nes classic and I can swap chips in and out. I have a chip that is 4x the size of the original (Same die, just more storage) and I am trying to figure out how to copy the original information on the chip over to the new one.

I have UART, and everything ready but using it and the commands is far above anything I have done before. Is there anyone in here that might be able to help me finish this project up?

Thanks,


Top
 Profile  
 
PostPosted: Sat Jun 10, 2017 9:30 pm 
Offline
User avatar

Joined: Sun Feb 14, 2010 8:38 pm
Posts: 287
Wow, I'd like to see some images of what you did.


Top
 Profile  
 
PostPosted: Sun Jun 11, 2017 4:09 pm 
Offline

Joined: Sat Jun 10, 2017 8:57 pm
Posts: 2
Image
Image

These are picture of the carrier open. I can swap the new chip and the original chip in and out. It still works and runs just fine with the original chip and it will load the kernel from hakchi just fine on the new one but it won't boot. Cluster told me I need to load the Nand and Uboot on the new one so I need to figure out how to get that done and then I can flash additional chips for people to get soldered on.

I know Uboot is in the source files from nintendo and I also know that the NAND has been decrypted by someone but doing all of that over the UART connection is way above my head. I need some guidance to help me get through it. I am not a Linux guy.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 124 posts ]  Go to page Previous  1 ... 5, 6, 7, 8, 9

All times are UTC - 7 hours


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group