Trying to Dump Metal Storm from Retrobit

Discuss hardware-related topics, such as development cartridges, CopyNES, PowerPak, EPROMs, or whatever.

Moderators: B00daW, Moderators

Post Reply
Posts: 1
Joined: Sun Jan 19, 2020 8:55 am

Trying to Dump Metal Storm from Retrobit

Post by mistermorcus » Sun Jan 19, 2020 9:09 am

I've been doing some research and trying to find out if it is possible to dump Metal Storm from Retrobit. I have seen it mentioned that it is using mapper 268 and is a variant of the Coolboy/Mindkids board. I found a pretty good writeup of it here: ... m.html?m=1

There is a photo of the pcb there, but I can take some more shots of mine that are a little clearer. I also found some more info in this thread where copynes scripts were converted to anago scripts, but since it was for a different rom I was not sure if it would work:


Unfortunately I don't know much about the scripts required for something like this. Some people have said that the kazzo can't maintain the proper m2 signal but in the other thread I referenced it seemed like if I start scanning at a certain location it would prevent the reset lockout. I appreciate any help that can be offered.

Ice Man
Posts: 546
Joined: Fri Jul 04, 2014 2:34 pm

Re: Trying to Dump Metal Storm from Retrobit

Post by Ice Man » Thu Jan 30, 2020 2:03 am

Mapper 268 is quite a clone of MMC3 with some extra:

Posts: 43
Joined: Tue Apr 01, 2008 2:36 pm

Re: Trying to Dump Metal Storm from Retrobit

Post by acem77 » Thu Mar 11, 2021 11:52 am

I am looking for similar help with jimpower nes, and the pcb looks similar.
My post with more details.

Post Reply