Are you new to 6502, NES, or even programming in general? Post any of your questions here. Remember - the only dumb question is the question that remains unasked.
Moderator: Moderators
-
Erockbrox
- Posts: 386
- Joined: Sun Nov 23, 2014 12:16 pm
Post
by Erockbrox » Mon Jan 25, 2021 11:57 am
I'm looking to get a NES cartridge shell machined out of something. I believe I need the CAD files for both pieces of the NES cartridge (front and back). Does anyone know if these files exists? Thanks.
-
Fisher
- Posts: 1166
- Joined: Sat Jul 04, 2015 9:58 am
- Location: -29.794229 -55.795374
Post
by Fisher » Wed Feb 03, 2021 3:57 am
I found
this model on Thingverse.
It says it comes with a FreeCad model.
Hope it helps.
