edo9300 wrote:I first modded the dsi when the 0.9 version was out, even if i didn't install it because of the various issues and used the 0.8, later i tried installing the 0.9 and noticed it wasn't booting, after that i tried installing some older versions of unlaunch and i installed the 0.7 and the 0.6, and checked if they were working or not, the 0.6 did, but i then returned to the 0.8, i have 2 nand backups i'm testing with no$gba. The first from when i reported the issue in this forum and you told me to check (that backup had unlaunch 0.8 installed), the second when the 1.2 came out after it didn't boot (that had unlaunch 1.2 installed) on both the backups, both the 1.2 and 1.3 works. I installed the 1.3 on both the backups from no$gba. As for the files in the backup, they're there, both the app and title tmd, with the correct size.
Thanks for the screenshots. Yes, looks as if you really have no$gba configured as needed. I am running out of ideas why it isn't working the same way on real hardware. Except, you could try to dump CURRENT eMMC content (as far as I understand you've installed v1.3 independently on hardware and in no$gba, so the dump may be still slightly different than real hardware).
If you had v0.9 installed first, then the launcher files were already write-protected (so later use of v0.6 won't cause any harm).
Did you try to hold down button Y in v1.3 to skip wifi init (or both Y+A, if you have sd card inserted)? Maybe that helps, though I wouldn't know why, unless you have some different wifi hardware than most people. Maybe it's really time to look at the mainboard and chipset. Aside from different wifi boards, there seem to be different BPTWL chips, and different sound/touchscreen controllers.
Well, or I could make a version with additional boot status messages, or with blank red/green/blue screens during the patched-launcher boot stages. That'd help to find out where it's hanging exactly.
Ah, and did you try hiyacfw? As far as I know, that's also booting into the official launcher, with similar patches as in unlaunch. Does that hang, too?
PS. I do currently have firmeware v1.4E on my console, and tested v1.4.5E only in no$gba, so I didn't check if v1.4.5E would hang on my console, too. But I guess a lot of other people have tested that and it's working without problems... If somebody has firmware v1.4.5E and unlaunch v1.3 installed: Could you test/confirm if it's working or hanging (when ejecting the SD card, or holding down button A during boot)?